Operating Instructions; Safety Instructions - Truma iNet Box Mode D'emploi

Operating instructions

Safety instructions

– Truma iNet Box must not be operated unless
it is in technically perfect condition.
– Operate the Truma iNet Box only with the
approved operating voltage.
– Repairs must be carried out immediately.
Only carry out repairs yourself if the solution
is described in the troubleshooting guide of
this manual.
– A defective Truma iNet Box may only be re-
paired by the manufacturer or the manufac-
turer's service department.
– Do not perform any modifications to the
Truma iNet Box as this can be dangerous.
– Do not switch on the appliance if the casing
is damaged or if liquid has entered it.
– Changes or modifications not expressly ap-
proved by the party responsible for com-
pliance could void the user's authority to op-
erate the equipment.
– This device complies with Part 15 of the
FCC Rules and with Industry Canada li-
cense-exempt RSS standard(s). Operation is
subject to the following two conditions:
(1) this device may not cause harmful inter-
ference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
– Le présent appareil est conforme aux CNR
d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouil-
lage, et
(2) l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si
le brouillage est susceptible d'en compro-
mettre le fonctionnement.
15