Headlight Adjustment - SWM OUTLAW 2018 Manuel D'utilisation Et D'entretien

HEADLIGHT ADJUSTMENT

When checking the proper aiming of the headlight
beam: inflate tyres at the right pressure, have a
person sit astride the motorcycle and set the mo-
torcycle perpendicular to its longitudinal axis
at 33 ft from a wall or screen. Then trace a hori-
zontal line at the height of headlight centre and a
vertical one, in line with vehicle longitudinal axis.
If possible, execute this operation in a shaded place.
When the low beam is on, the upper edge between
dark and lit zone should be at 9/10th of headlight
centre from ground.
10m
Beam height can be adjusted as follows:
- Loosen the two screws (1).
- Adjust the position of the headlight (2) and then
tighten the screws (1).
2
9
X
10 X
1
EN - 51