SWM OUTLAW 2018 Manuel D'utilisation Et D'entretien page 90

AIR FILTER CHECK AND/OR REPLACEMENT
- Remove the RH side panel as described in the rela-
tive paragraph.
- Undo the screws (1) and remove the filter cover (2).
- Remove the filter (3) and check its condition; to
clean it, blast it with compressed air from the out-
side to the inside; if it is very dirty, replace it.
- Refit everything operating in reverse order from
removal.
2
3
EN - 32
1
SPARK PLUG CHECK
Spark plug (3) gap shall be 0,7 ÷ 0,8 mm (0,02 ÷ 0,03
in).
A wider gap may cause difficulties in starting the
engine and overload the coil.
A gap that is too narrow may cause difficulties
when accelerating, when idling or poor performance
at low speed.
- Remove the cap (1).
- Insert the wrench provided (2) and remove the
spark plug (3).
3
1
2
3