SWM OUTLAW 2018 Manuel D'utilisation Et D'entretien page 78

THROTTLE CONTROL
The throttle twistgrip (1) is located on the right-
hand side of the handlebar.
FRONT BRAKE CONTROL
The brake control lever (2) is located on the right-
hand side of the handlebar. A stop switch, during
the braking action, causes the stop light on the tail
light to come on. The position of the throttle con-
trol can be adjusted by loosening the two retaining
screws (B).
CAUTION*: Do not forget to tighten the screws
(B) after the adjustment.
B
1
2
EN - 20
CLUTCH CONTROL
The clutch control lever (1) is located on the left-
hand side of the handlebar and is equipped with a
protection.
The clutch control position on the handlebar can be
adjusted by loosening the retaining screws (A).
CAUTION*: Do not forget to tighten the screws
after adjustment.
1
B
A
REAR BRAKE CONTROL
The rear brake control (1) is placed on the right-
hand side of the motorcycle. A stop switch, during
the braking action, causes the stop light on the tail
light to come on.
1
1
GEAR SHIFT CONTROL
The lever (1) is placed on the left-hand side of the
engine. The operator must release the lever after
each gear change to allow it to return to its central
position. Neutral position (N) is between the first
and second gears.
First gear is engaged by pushing the lever down-
wards; the other gears are engaged in a sequence
by pushing the lever upwards.
The position of the gear shift lever on the shaft can
be varied as follows: loosen the screw,
lever out, and place the lever in a new position on
the shaft.
Tighten the screw once operation is completed.
pull the