Grizzly BRM 51-159 A-OHV Quattro Traduction De La Notice D'utilisation Originale page 81

- Fill with petrol before starting the
engine. Do not open the filler cap or
refill with petrol whilst the engine is
running or the equipment is hot:
- If petrol is spilled, do not attempt to
start the engine. Instead, remove
the equipment from the surface on
which the petrol has been spilled.
Avoid any ignition attempt until the
petrol fumes have evaporated;
- For reasons of safety, replace petrol
and other filler caps in the event of
damage.
• Replace defective silencers.
• Before use, always carry out a visual
inspection to check whether the cut-
ting tools, mounting bolts and entire
cutting unit are worn or damaged. To
avoid imbalance, only replace worn or
damaged tools and bolts in sets.
• Take care with equipment that has
several cutting tools, as the move-
ment of one blade may result in rota-
tion of other blades.
• Use only replacement parts and ac-
cessories supplied and recommended
by the manufacturer. The use of parts
from other manufacturers may result
in injuries and will result in immediate
invalidation of the guarantee.
Handling:
• Do not run the combustion engine in
enclosed spaces, in which dangerous
carbon monoxide can collect.
• Mow only in daylight or with good
artificial lighting. An unlit working area
can result in accidents.
• If possible, avoid using the equipment
on wet grass.
• Always ensure secure positioning,
particularly on hillsides, landfills,
ditches or dykes. This will give you
better control of the equipment in un-
expected situations.
- Always work across the slope,
never upwards or downwards.
- Take particular care when changing
the direction of travel on the slope.
- Do not mow on excessively steep
slopes (max. 10°).
• Run the equipment only at walking
speed.
• Take particular care when turning the
equipment around or pulling it towards
you.
• Stop the cutting tool if the equipment
has to be tipped up for transportation
over a surface other than grass and
when moving the equipment from and
to the surface to be mown.
• Do not use the equipment with dam-
aged safety equipment or guards or
with no safety equipment attached,
e.g. impact protection and/or grass
catchers. This ensures that the equip-
ment remains safe.
• Do not change the engine regulator
setting and do not over-rev it. This
may damage the equipment.
• Before starting, the engine, disengage
all cutting tools and drives.
• Start or operate the start switch with
care and in accordance with the
manufacturer's instructions. Ensure
sufficient space between feet and the
cutting tool. Risk of injury.
• When starting or activating the en-
gine, do not tip the equipment unless
the equipment has to be lifted for
this procedure. In this case, tip the
equipment only as far as is absolutely
necessary and lift only the side that is
away from the user.
• Do not start the engine when standing
in front of the ejection channel.
• Switch on the engine in accordance
with the instructions and only if your
UK
81