Heat Shield Stand-Off Removal (See-Thru Installation Only); Louvre Installation - Napoleon BGD40GN Instructions D'installation Et D'utilisation

Table des Matières

Publicité

30
6.3

HEAT SHIELD STAND-OFF REMOVAL (SEE-THRU INSTALLATION ONLY)

When using a non-combustible
fi nishing material, the stand-offs
may be removed, by removing the
set screw in the centre and sliding
the stand-offs out of the mounting
clips.
* The top extension may be
removed if non-combustible
framing is faced with a non-
combustible material placed fl ush
with the front face of the appliance
and extending from the top of the
appliance. Example: Cement
board (not supplied). Combustible
counter / bar tops must maintain a
minimum of 38" from the base of
the appliance to the underside of the top.
NOTE: Wolf Steel trim and/or surround kits will not
totally cover the top extension of the appliance. In
f i r e - p a r t s . c o m
order to obtain a smooth transition from the trim /
surround to the wall, it is recommended that the top
extension be removed and the appliance be installed
following the above procedure.
6.4

LOUVRE INSTALLATION

A
B
C
W415-1028 / A / 08.13.12
All manuals and user guides at all-guides.com
END HEAT
SHIELD SHOWN
CLIPS
CENTRE SLOT
A
HOOD
Attach the hood by
pressing the top fl ange
into the clips along the
top of the louvre open-
ing. Secure using a
screw through the centre
slot.
SLOT
TAB
B
UPPER LOUVRES
Insert the louvre tabs
into the slots located
at the top left and right
corners of the unit.
SLOT
HINGE CLIP
C
LOWER LOUVRES
Insert the hinge clips
into the slots located at
the bottom left and right
corners of the unit. To
remove the louvres, pull
the back tabs of the clips
forward, while pushing
the louvre assembly
back. Lift the clip.
57.2

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Bgd40gp

Table des Matières