Quick Commissioning; Memorising The Keygo Io Remote Controls For Operation In Complete Opening Mode; Self-Learning - SOMFY ELIXO 500 3S io Manuel D'installation

Elixo 500 3S io

quICK COMMISSIOnIng

Memorising the Keygo io remote controls for operation in complete opening mode

If this procedure is carried out using a channel which has already been
memorised, this channel will be cleared.
[1]. Press and hold the "prOg" button (2 s) on the programming interface.
The screen displays "F0".
[2]. Press the outer left and right buttons on the remote control together.
The remote control indicator light flashes.
[3]. Press the button of the remote control that will open the gate fully.
The screen displays "Add".

Self-learning

Self-learning allows the gate's speed, maximum torque and slowdown zones to be adjusted.
- Auto programming the gate's travel is essential when commissioning the motor.
- The gate must be in the intermediate position before self-learning starts.
- During self-learning, the obstacle detection function is not active. Remove any objects or obstacles and do not allow any
persons near or inside the operating range of the motorisation.
- To carry out an emergency stop during self-learning, use a stored remote control or press one of the interface buttons.
Start self-learning
[1]. Press and hold the "SEt" button (2 s).
Release the button when the screen displays "h1".
[2]. Press "OK" to start self-learning.
Self-learning must start with the gate being opened.
The gate performs two complete Opening and Closing cycles.
[1]
2 s
2 s
h0 h1
• If self-learning starts when the gate is closed, stop the self-learning in progress
(press a control button: motor electronics, memorised remote control, wired
control point, etc.), move the slide as shown opposite, then restart self-learning.
• If self-learning is correct, the display indicates "C1".
• If self-learning has not completed correctly, the display indicates "h0".
At the end of installation, it must be checked that the limitation of forces complies with appendix A of the standard EN 12 453.
9
[2]
[1] [2]
2 s
h0 f0
h2
h4
h2
C1
h4
h0
Copyright © 2015 Somfy SAS. All rights reserved.
[3]
add h0
Self-learning correct
Self-learning incorrect