Diagnostics; Operating Code Display; Programming Code Display - SOMFY ELIXO 500 3S io Manuel D'installation

Elixo 500 3S io

dIagnOStICS

Operating code display

Code description
C1 Awaiting command
C2 Gate opening
C3 Awaiting gate closure
C4 Gate closing
C6
Detection in progress for cell safety
C7 Detection in progress for safety edge
safety
C8 Detection in progress for programmable
safety
C9 Detection in progress for emergency
stop safety
C12 Reinjecting current
C13
Safety device autotest in progress
C14 Permanent complete opening wire
control input
C15 Permanent pedestrian opening wire
control input
C16 BUS cell programming refused
Cc1 9.6 V power supply
Cu1 24 V power supply

programming code display

Code description
h0 Awaiting setting
hc1 Awaiting setting + 9.6 V power supply
hu1 Awaiting setting + 24 V power supply
h1 Awaiting start of self-learning
h2 Self-learning mode - opening
h4 Self-learning mode - closing
f0 Awaiting remote control memorisation for
operation in complete opening mode
f1 Awaiting remote control memorisation for
operation in pedestrian opening mode
f2
Awaiting remote control memorisation
for remote lighting control
f3 Awaiting remote control memorisation
for auxiliary output control
23
Comments
Automatic closing time delay P02, P04 or P05 in progress.
Displayed during a movement request or during movement when detection is in progress on the safety input.
The display appears for as long as detection is in progress on the safety input.
Displayed while the autotest is running on the safety devices.
Indicates that the complete opening wire control input is permanently activated (contact closed). Commands coming
from the radio remote controls are then disabled.
Indicates that the pedestrian opening wire control input is permanently activated (contact closed). Commands coming
from the radio remote controls are then disabled.
Check that the BUS cells (wiring, alignment, etc.) are operating correctly
Displayed during operation with 9.6 V backup battery
Displayed during operation with 24 V backup battery
Comments
Pressing and holding the "SEt" button for 2 seconds starts self-learning mode.
Displayed during operation with 9.6 V backup battery
Displayed during operation with 24 V backup battery
Pressing the "OK" button starts the self-learning cycle.
Pressing the "+" or "-" button allows the motor to be controlled in forced operation mode.
Pressing a button on the remote control allocates this button to the motor complete opening control.
Pressing "prOg" once more switches to "awaiting remote control memorisation for operation in pedestrian opening
mode: f1".
Pressing a button on the remote control allocates this button to the motor partial opening control.
Pressing "prOg" once more switches to "awaiting remote lighting control memorisation: f2".
Pressing a button on the remote control allocates this button to the remote lighting control.
Pressing "prOg" once more switches to "awaiting auxiliary output control memorisation: f3".
Pressing a button on the remote control allocates this button to the remote lighting control.
Pressing "prOg" once more switches to "awaiting remote control memorisation for operation in complete opening
mode: f0".
Copyright © 2015 Somfy SAS. All rights reserved.