Decommissioning, Storage, Disposal; Decommissioning; Storage; Correct Disposal Of The Unit - Mettler Toledo EasyClean 200e Instructions D'utilisation

EasyClean 200e

7 Decommissioning, storage, disposal

Sorting
EasyClean 200e
30 404 676 F
DANGER
Please refer to section 2 "Safety".
Decommissioning may only be performed by trained staff or specialists.

7.1 Decommissioning

Procedure
1. Switch off the power supply, the compressed air supply and the water supply to the device.
2. Disconnect the device from the main switch.
3. Disconnect any signal leads used.
4. Disconnect leads for compressed air.
5. Remove the EasyClean from its mounting.
6. Rinse the hoses and valves with fresh water.
7. Clean the device with a damp cloth.
8. Allow the device to dry.

7.2 Storage

Store the EasyClean in a dry place, as described in section 1.3.

7.3 Correct disposal of the unit

When the EasyClean is finally removed from service, observe all local environmental regulations
for proper disposal.
Sorting takes place by placing the device into waste groups as listed in the current European
Waste Catalogue (EWC). This catalogue is valid for all waste, whether it is intended for
disposal or recycling.
The packaging contains the following materials:
– cardboard
– foam plastic.
The device contains the following materials:
– steel
– electronic materials (cables, components, programmable control)
– various components as described in the printed description.
39
02/2021 © METTLER TOLEDO
Printed in Switzerland