Functions - Mettler Toledo EasyClean 200e Instructions D'utilisation

EasyClean 200e
General
Types of operation
Basic setting
"HOLD" function
Messages
EasyClean 200e
30 404 676 F

3.2 Functions

The EasyClean 200e is designed for the automatic rinsing and cleaning of electrodes in
retract able housings.
The EasyClean is supplied with a predefined rinsing and cleaning process. Both the rinsing
and cleaning time can be adjusted by the operator to suit the individual local conditions.
The individual processes are instigated by switching on the washing contact on the connected
transmitter.
An integrated programmable logic controller controls the whole rinsing and cleaning procedure.
The EasyClean has no main switch, and is always in active status.
When the EasyClean 200e is switched off, the electrode is removed from the process medium.
If the EasyClean 200e is connected to the mains, the housing and sensor move into
the measuring position.
The message "RUN" appears on the display. The EasyClean is ready for operation.
The "HOLD" function is a function of the transmitter. This function suppresses the measured
values of the sensor during a work cycle of the EasyClean.
NOTICE
If the transmitter is usually used with exit points, a "HOLD" function is absolutely necessary.
Signals that can be measured through cleaning with acids or alkalis might otherwise activate
the transmitter control.
The integrated control is equipped with a display.
This displays the current function status of the control.
17
02/2021 © METTLER TOLEDO
Printed in Switzerland