How To Connect The Outputs Of The Controller; J6 - Serial - Agilent Technologies TPS-compact Mode D'emploi

How to Connect the Outputs of the Controller

The following figure shows a typical logic output connection (relay
coil) but any other device may be connected e.g. a LED, a computer,
etc., and the related simplified circuit of the controller. The figure
example refers to the programmable set point signal on pins 11
and 9.
J6 – Serial
This is a 9 pin D-type serial input/output connector to control via an
RS 232 or RS 485 connection the TPS-compact.
TPS-compact User Manual / 87-901-010-01 (H)
Technical Information
Interconnections
287/314
17