Operating Instructions; Operator Controls; Operation - Enraf Nonius Radarmed 650+ Mode D'emploi

Masquer les pouces Voir aussi pour Radarmed 650+:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

ENGLISH

8 Operating instructions

8.1

Operator controls

[1] Indication LED therapy mode
The illuminated LED indicates the selected mode; continuous or pulsed.
[2] Selector therapy mode: continuous [symbol] or pulsed microwave [symbol]
The unit automatically switches to continuous mode when switched on or at the end of treatment. It is
possible to switch from continuous to pulsed mode and visa versa during treatment.
[3] Display treatment time
The display shows the set c.q. remaining treatment time in minutes. When the time is expired a zero
appears on the display, a sound signal is audible and the HF-power switches off. A flashing dot in the
display means the clock is running and treatment started.
[4] Treatment time setting selectors
These selectors are used to set the treatment time.
[5] Power display
The display shows the set power. A flashing zero on the display indicates that no treatment time has been
set. In this case it is not possible to set the power.
[6] Power setting selectors
These selectors are used to set the power. It is only
possible to set the power if also a treatment time has been
set.
[7] Stop button
Button to end a treatment premature. After operation of
this button the treatment time runs down to zero, a sound
signal is audible and the HF-power is shut off.
[8] On/off switch
With this switch the Radarmed is turned on/off.
[9] Ventilation slots
These openings must be kept clear for ventilation.
[10] Connection points electrode arm
The electrode arm can be connected at choice at the left
or right side of the unit (see paragraph 7.6 of this manual).
[11] Hook for mains cable
Hook to hang up the mains cable when the unit is out of

operation.

Page 12 of 19
081-400-095-49_EN

Publicité

Table des Matières
loading

Table des Matières