Electrical Connection And Setting For One Tank; Electrical Connection And Setting For Two Tanks - DAB AQUATWIN TOP 132 Instructions Pour L'installation Et La Maintenance

25–26 Spare terminals (not enabled
FU1
Disabled fuse
Fuses protecting the electronic board transformer against short circuiting of the primary circuit and of its supply line.
FU2
Electrical characteristics: 5x20T 100mA
Fuses protecting the transformer against incorrect connection of the motor cables (check the thermal protection). FUNCTION
FU3
NOT USED
Fuse protecting the electropump P1 against short circuiting.
FU4
Electrical characteristics: 10x38 16A (aM)
Switch off power before performing maintenance.
Fuses protecting the electropump P2 against short circuiting.
FU5 Electrical characteristics: 10x38 16A (aM)
Switch off power before performing maintenance.
Fuse protecting the transformer against short circuiting of the primary circuit and of its supply line.
FU6
Electrical characteristics: 10.3x38 1A tipo (gG)
Fuse protecting the transformer against short circuiting of the secondary circuit and of the low voltage auxiliary circuit line.
FU7
Electrical characteristics: 10.3x38 1A tipo (gG)

9. ELECTRICAL CONNECTION AND SETTING FOR ONE TANK

For operation of the AQUATWIN TOP in configuration with a single rain water collection tank, proceed as follows: connect the float (- G1) in the
rain water collection tank to the terminals ( 1- 2 ) and set the control unit (MC1) in 1 TANK mode with the button (
N.B. In the case of a single tank the two intakes can be combined in a single suction pipe.

10. ELECTRICAL CONNECTION AND SETTING FOR TWO TANKS

For operation of the AQUATWIN TOP in configuration with two separate rain water collection tanks, proceed as follows:
Connect the float (-G1) in the first rain water collection tank to the terminals (1-2)

Connect the float (-G2) in the second rain water collection tank to the terminals (3-4)

Set the control unit (MC1) in 2 TANKS mode with the button (

ENGLISH
H1 G1 G2 G3 G4
)
44
EV
G5
EV1 EV2
)