Operating Instructions; Selecting The Active Wavelength; Signal Modulation - Promax PROLITE-105 Manuel D'utilisation

USER'S MANUAL. PROLITE-105
[7] Connector SC / APC Fibre signal output or active signals.
[8] Anchor Point conveyor belt.
[9] External power input of 12 V.

4.2 Operating Instructions

The PROLITE-105 is a device easy to use that can be operate using only three
keys: one to select the wavelength and to turn on / off the modulation of the laser, one
key to activate the sequencing mode and the key to turn on/off the instrument.

4.2.1 Selecting the active Wavelength.

The PROLITE-105 is a source of laser that can emit in three different
wavelengths: 1310 nm, 1490 nm and 1550 nm. It can emit these three wavelengths
simultaneously.
The LED corresponding to the active source wavelength is in green. When it is
modulated it is in amber.
Pressing on any of these keys of the wavelength
repeatedly, it switches between continuous and modulated laser light.
To switch off the laser light you have to press for few seconds the key
corresponding to the active wavelength until the LED turns off.

4.2.2 Signal Modulation

The PROLITE-105 can modulate the three wavelengths with an internal signal.
For the 1310 nm wavelength it uses a modulation frequency of 270 Hz. For the
1490 nm and 1550 nm corresponds a modulation of 1 kHz and 2 kHz respectively.
In order to activate the modulation of the output signal, you should press twice the
key corresponding to the wavelength. When the signal is modulated, the LED is
AMBER.
To disable the signal modulation you should press again the activation key. The
LED corresponding to the active wavelength will turn to green, indicating the output
signal is no longer being modulated.
03/2011
, , [4]
Page 9