Commissioning; Operation; Initialisation Of The Memory Card, Brightness Settings, Select Folder - VOLTCRAFT 2002024 Notice D'emploi

12. COMMISSIONING

First connect the voltage supply. Always connect the low-voltage plug (hollow plug) first to the connection cable of
the mains unit to the DC input socket of the charger. Then the mains unit must be connected to the corresponding
protective contact mains socket via the mains cable.
Alternatively to the enclosed mains unit, a suitable car adapter can also be used for voltage/current supply
(not enclosed, can be ordered separately). The adapter must be able to supply na output voltage of 12 V/DC
and an output current of 5 A.
The display now shows a brief animation. During this time, the charger carries out a self-test and checks for any
inserted rechargeable batteries.
This animation is only shown if the buffer memory is empty.
The charger is then ready for operation.

13. OPERATION

a) Initialisation of the Memory Card, Brightness Setting, Select Folder
Without inserted rechargeable batteries and SD/SDHC memory card, the following display appears:
1 Note that no rechargeable batteries are inserted: „NO CELL INSERTED"
2 Memory card status display: „NO SD CARD AVAILABLE" means that data recording is not possible because
either no memory card has been inserted, the memory card is write-protected or not compatible.
3 Detailed display of the memory card status, incl. total memory capacity and still available memory
4 Brightness setting of the LC display
You can now adjust the backlight brightness. Turning the wheel encoder now can adjust the brightness in nine levels
(from 0 - 8) or „AUTOMATIC", with stage 0 switching off the backlight entirely. For „AUTOMATIC", the brightness is
reduced step by step if no user interaction takes place.
44