Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
10
GAS SECTION
The walls adjacent to the cooker must be
of material resistant to heat.
GAS CONNECTION
The connection must be executed by
a qualified tecnician according to the
relevant standards.
The appliance is predisposed and
calibrated to operate with the gas
indicated on the specifications plate.
Before installation, make sure that
the local distribution conditions
(type of gas and its pressure) and
the adjustment of this appliance
are compatible. The appliance
adjustment conditions are given on
the plate or the label.
232
Ensure that the room in which the cooker
is to be installed is adequately ventilated,
in compliance with applicable regulations.
Connection to the gas supply pipe or gas
cylinder must be made in accordance
with the requirements of the applicable
regulations.
The gas supply is connected at the rear of
the cooker (fig. 10.1) to the R or L terminal
of the gas inlet pipe; the connection pipe
must not cross the rear of the appliance.
The terminal not used must be closed off
with the plug T and gasket.
R
L
T
Fig. 10.1
Publicité
Table des Matières
