Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
TELESCOPIC
SUPPORTS
The telescopic sliding shelf supports make
it safer and easier to insert and remove the
oven shelf and tray. They stop when they
are pulled out to the maximum position.
Important! When fitting the sliding shelf
supports, make sure that you fit:
•
The slides to the top wire of a rack.
They do not fit on the lower wire.
•
The slides so that they run out towards
the oven door.
•
Both sides of each pair of shelf slides.
•
Both sides on the same level.
To fix the sliding shelf support onto the side
racks:
•
Screw the side racks onto the oven
walls (figs. 8.6a, 8.6b, 8.6c).
•
Fit the sliding shelf support onto the
top wire of a rack and press (fig. 8.9).
You will hear a click as the safety locks
clip over the wire.
To remove the telescopic sliding shelf
supports:
•
Remove the side racks by unscrewing
the fixing screws (fig. 8.10).
•
Lay
down
shelf support and side racks, with
the telescopic sliding shelf support
underneath.
•
Find the safety locks. These are the
tabs that clip over the wire of the side
rack (arrow 1 in fig. 8.11).
•
Pull the safety locks away from the wire
to release the wire (arrow 2 in fig. 8.11).
Cleaning the sliding shelf supports:
•
Wipe the supports with a damp cloth
and a mild detergent only.
•
Do not wash them in the dishwasher,
immerse in soapy water, or use oven
cleaner on them.
220
SLIDING
SHELF
the
telescopic
sliding
Left
1
2
Fig. 8.9
Right
Fig. 8.10
1
Fig. 8.11
Publicité
Table des Matières
