BORETTI CFBG903AN Prescriptions De Montage Et Mode D'emploi page 199

CHOICE OF THE BURNER
On the control panel, near every knob there is a diagram that indicates which burner is
controlled by that knob.
The suitable burner must be chosen according to the diameter and the capacity used.
As an indication, the burners and the pots must be used in the following way:
DIAMETERS OF PANS WHICH MAY BE USED ON THE BURNERS
BURNERS
Auxliliary
Semi-rapid
Rapid
Dual (with ONLY inner crown operating)
Dual (with inner + outer crown operating)
Maximum diameter for woks: 36 cm
do not use pans with concave or convex bases
It is important that the diameter of the pot be suitable to the potentiality of the burner so as
not to compromise the high output of the burners and therefore energy waste.
A small pot on a large burner does not give you a boiling point in a shorter amount of time
since the capacity of heat absorption of a liquid mass depends on the volume and the
surface of the pot.
MINIMUM MAXIMUM
12 cm 14 cm
16 cm 24 cm
24 cm 26 cm
12 cm 14 cm
26 cm 28 cm
Fig. 3.5
199