Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SETTING THE MINIMUM OF THE
COOKTOP BURNERS
When switching from one type of gas to
another, the minimum flow rate must also
be correct: the flame should not go out even
when passing suddenly from maximum to
minimum flame.
To regulate the flame follow the instructions
below:
Auxiliary, semi-rapid and rapid burners:
•
Light the burner.
•
Set the gas valve to the "minimum
rate" position.
•
Remove the knob.
•
Using a screwdriver turn the screw
"F1" until adjustment is correct (fig.
10.12).
Inside crown of DUAL burner:
•
Light the DUAL burner.
•
Set the gas valve to the "minimum
rate" position of the inner crown only.
•
Remove the knob.
•
Using a screwdriver turn the screw
"F3" until the correct setting is obtained
(fig. 10.13).
Outside crowns of DUAL burner:
•
Light the DUAL burner.
•
Set the gas valve to the "minimum rate"
position of the inner + outer crowns.
•
Remove the knob.
•
Using a screwdriver turn the screw
"F2" until the correct setting is obtained
(fig. 10.13).
For LPG gas, tighten the adjustment
screws completely.
F
F1
F2
F3
Fig. 10.12
Fig. 10.13
241
Publicité
Table des Matières
