Fitting The Floor Tool; Filling The Clean-Water Tank - Numatic TT 516 Mode D'emploi

Fitting the Floor Tool

The floor tool has been designed for quick fitting, allowing easy squeegee blade replacement and a safety knock-off
feature if the floor tool gets snagged, whilst in transit.
Note The lever moves upward and backward motion to lock the floortool in the raised position.
Note:
It is easier to fit the floor-tool if the weight of the machine is resting on the brush. Ensure the brush is fitted first.

Filling the clean-water tank

The TT 516 is equipped with a large 5 gall clean-water tank allowing large areas to be cleaning in a single fill.
Note.
Great care must be taken to ensure that contaminants (leaves, hair, dirt, etc) are not allowed to enter the
clean-water tank during the filling process.
If using a bucket or similar, ensure it is always clean and free from debris.
The floor tool carrier can be
raised and locked from moving
by operating the locking lever,
upwards and backwards.
this lever can be found next to the
lower section of the handle.
Unlock and swing the floor-tool
carrier to the side of the machine
(Fig 8).
Secure to the carrier using the
two knobs fitted to the floor-tool
carrier (Fig 9) - (Fig 9a).
Do not over tighten the retaining
knobs.
Fig 9
To fill the clean-water tank, remove the filler cap (Fig 10).
Fig 10
Fill using a hose, bucket or a suitable container. (Fig 11).
Fig 11
5
Machine Set-Up
Fig 8
Fig 9a