Assembly - Cleanmaxx PC-P008E Mode D'emploi

EN
d
6. First disconnect the mains adapter from the mains power and then disconnect the
barrel connector from the charging station.
7. Remove the battery from the charging station.

Assembly

Attaching / Removing the Electrical Floor Nozzle, the turbo upholstery
nozzle and Extension Tube
No adapter is required for the electrical fl oor nozzle (9), turbo upholstery nozzle and the
extension tube.
• They are plugged directly onto the suction opening (8). The catches must be heard
to engage in place. Attach the electrical fl oor nozzle or the turbo upholstery nozzle
to the extension tube in the same way.
Attaching / Removing the brush nozzle and tile nozzle
The brush nozzle (10) and the tile nozzle (11) are attached with the aid of the nozzle
adapter.
• Plug the nozzle adapter into the suction opening (8).
• If desired, fi rst plug the extension tube into the suction opening and second the
nozzle adapter to the extension tube.
• Plug the nozzle you want onto the nozzle adapter.
• To take them apart, pull the nozzle and the adapter apart.
Removing / Inserting the Dust Container
closed
open
2. Insert the battery into the charging station. The three con-
tacts of the battery must rest on the three contacts (a) of
the charging station.
3. First plug the barrel connector on the cable of the mains
adapter (13) into the socket (c) of the charging station and
then connect the mains adapter to the plug socket.
a
4. The green operating lamp (b) and the red charge control
b
lamp (d) will light up. The battery is being charged.
5. When only the green operating lamp is still lit, the battery
c
is fully charged.
• To detach it, press the release button and pull the electrical
fl oor nozzle, the turbo upholstery nozzle or the extension
tube out at the same time.
• Removing: Twist the dust container (7) a little bit. It is re-
leased from the main unit (3) and can be removed.
• Inserting: Insert the dust container into the main unit. Ro-
tate it slightly as you do this until it engages in the main unit
correctly. Then twist the dust container in the main unit to
secure it in place. The release button of the dust container
must be located below the suction opening (8) after it has
been attached.
22