Device"/"Usb" Menu - Sartorius Entris II BCE Série Mode D'emploi

Parameter Setting values
DATABIT 7 BITS
8 BITS*
* Factory setting
7 .3 .4

"DEVICE"/"USB" Menu

Parameter Setting values
DAT .REC .** XBPI
SBI*
REM .DISP .
PC .SPREA .
YDP20
YDP30
PC . T EXT
OFF
BAUD** 600, 1200, 2400,
4800, 9600*,
19200, 38400,
57600, 115200
PARITY** ODD*
EVEN
NONE
HANDSHK .** SFTWARE
HARDW .
NONE*
DATABIT** 7 BITS
8 BITS*
DEV .USED NONE*, PRINTER,
VIRT .COM, PC
HOST, REM .DISP .
* Factory setting
** Are blocked if "PRINTER" or "REM .DISP ." are displayed under "DEV .USED"
Explanations
Sets the number of data bits to 7 .
Sets the number of data bits to 8 .
Explanations
Extended range of commands to control numerous balance functions with
binary protocol for direct communication with the device .
Enables SBI communication . The data is output to a PC or control unit . Enables
the use of ESC commands from a PC to control the basic balance functions with
ASCII protocol .
Enables data output on another display .
Enables data output to a spreadsheet program via a direct PC connection .
Sets the standard settings of YDP20 printers .
Sets the standard settings of YDP30 printers .
The balance transmits the data via keyboard command to the currently opened
application on the PC in text format .
Deactivates the data output .
Sets the baud rate to the selected value .
Applies an odd parity .
Applies an even parity .
Does not apply a parity .
Sets the handshake protocol to software handshake .
Sets the handshake protocol to hardware handshake .
Does not set a handshake protocol .
Sets the number of data bits to 7 .
Sets the number of data bits to 8 .
Indicates which connection is detected at the USB port .
System Settings
Entris BCE Operating Instructions
®
21