"Applic ."/"Statist ." Menu; "Applic ."/"Peak .Hld ." Menu; "Applic ."/"Check . W G ." Menu - Sartorius Entris II BCE Série Mode D'emploi

7 .3 . 1 7

"APPLIC ."/"STATIST ." Menu

Parameter Setting values
PRT .COMP . OFF
ON*
TAR .STAT . OFF*
ON
* Factory setting

7 .3 . 1 8 "APPLIC ."/"PEAK .HLD ." Menu

Parameter Setting values
APPLY AT STAB .*
W/O STB .
* Factory setting

7 .3 . 1 9 "APPLIC ."/"CHECK . W G ." Menu

Parameter Setting values
INPUT MANUAL*
WG . V ALUE
AUTO .PRT . OFF*
ON
OK ONLY
NOT OK
* Factory setting
Explanation
Deactivates the component printout .
Activates the component printout .
Deactivates automatic taring after the components are saved .
Activates automatic taring after the components are saved .
Explanation
Peak values are applied when there is stability .
Peak values are applied without stability .
Explanation
The min/max limits are entered manually .
The entry of the min/max limits is carried out by applying the weight value .
The automatic printing is switched off .
With automatic printing, all values are exported .
With automatic printing, only values that are within the control range are
exported .
With automatic printing, only values that are outside the control range are
exported .
System Settings
Entris BCE Operating Instructions
®
27