Selecting Convertible Units And; Their Decimal Places; Running The "Statistics" Application; Printing Weighing Result With Id Marking - Sartorius Entris II BCE Série Mode D'emploi

8 . 1 1 .2 Selecting Convertible Units and their
Decimal Places
Procedure
Press and hold down the [Toggle between weight
t
units] button .
Select one of the parameters "Unit 1" – "Unit 4" in the
t
submenu . To do so, press the [Confirm] button .
Select the desired unit . To do so, press the [Confirm]
t
button .
Specify the decimal places for the selected unit . To do
t
so, press the [Confirm] button once again .
Select the desired number of display digits . To do so,
t
press the [Confirm] button .
8 . 1 1 .3

Running the "Statistics" Application

The "Statistics" application saves up to 99 weight values
and evaluates these statistically .
The following values are saved and exported:
− Number of components
− Mean value
− Standard deviation
− Variation coefficient
Sum of all values
− Lowest value (minimum)
− Highest value (maximum)
− Spread: Difference between maximum and minimum
Requirements
− A printer or a PC is connected and configured .
− The "STATIST ." application is selected .
Procedure
Place a sample on the weighing pan .
t
To save the weight value: Press the [Confirm] button .
t
The position of the saved value is displayed, e .g . "NO
y
1" .
The recording of the statistics starts .
y
Remove the sample on the weighing pan .
t
To save the next value:
t
Place a new sample on the weighing pan and press
t
the [Confirm] button .
To switch between the display of the current weight
t
value, the number of saved components, and the
calculated mean in the results display: Press the [Up]
or [Down] button .
To delete all saved values: Press the [Back] button .
t
The evaluation is printed and the active GLP print is
y
ended .
To print and exit the current statistics, and to delete
t
the saved values: Press the [GLP] button .
8 . 1 2 Printing Weighing Result with
ID Marking
The device, the sample and a batch can be assigned an ID
number . The ID numbers are exported during GLP-
compliant printing .
Requirements
− The identity number is specified (see Chapter "7 .3 .20
"INPUT" Menu", page 28) .
− The printing of the lot ID line in the GLP printout is
activated in the menu (see Chapter "7 .3 .20 "INPUT"
Menu", page 28) .
− The "SPL . ID" output is activated in the menu .
− The GLP-compliant printout is activated (see Chapter
"7 .3 .7 "DATA .OUT ."/"PRNT .PAR ." Menu", page 23) .
Procedure
Start the printout . To do so, press the [Print] button .
t
The GLP header is printed with the ID marking of the
y
LOT ID set in the menu and the current weight value .
The [GLP] button appears in the operating display .
y
Confirm the [PRINT] button .
t
The SPL . ID and the current weight value are exported .
y
Confirm the [PRINT] button .
t
The SPL . ID and the current weight value are exported .
y
To exit the GLP printout: Press the [GLP] button .
t
The GLP footer is printed .
y
Entris BCE Operating Instructions
®
Operation
33