Anti-Theft Locking Device; Moving The Balance; Transporting The Balance - Sartorius Secura Notice D'installation Et D'utilisation

Lift cover plate out of the bottom
t
of the balance.
Warning: When doing this, put the
balance to one side and not on the
side of the weighing pan.
Attach a wire (or similar) to the
t
sample and hang it on the notched
hook.
h
If the below-balance weighing port is no longer being
used, close the opening with the cover plate again, so that
the weighing results are not adversely affected by drafts.
The below-balance weighing port may not be opened or
used on balances used for legal metrology.

Anti-Theft Locking Device

A Kensington lock can be installed
t
at the fastening point on the back of
the balance if required.
The balance can also be secured at
t
the installation location with a chain
and lock, for example.

Moving the Balance

Before moving the balance, switch it to the standby mode first, then
unplug the power connector and remove the weighing pan and the
pan support from the balance.
Moving the Balance over Short Distances in the Lab
h

Transporting the Balance

h
h
Secura
1
2
3
4
5
6
Quintix
Practum
1
2
3
4
Avoid glass breakage,
shocks, and vibrations:
Never lift and carry the
balance by its draft
shield.
Installation and Operating Instructions Secura
English
Hold the balance under the housing,
t
lift it up carefully, and carry it to its
new location.
The balance needs to be re-leveled and adjusted each time
its setup location is changed.
Prior to shipping, switch the balance to standby mode
(see next page) and then pull the plug.
Please use the original packaging for shipping.
Packaging can be ordered through the Sartorius Service
Center if required.
®
Models: Remove the following parts from
t
the balance:
– Draft ring (1) for models with 0.1 mg
readability
– Weighing pan (2)
– Pan support (3)
– Centering ring (4) for models with
0.1 mg readability
– Shield disk (5)
– Remove glass panels from the draft
shield (6): see next chapter, "Care and
Maintenance."
®
and
Remove the following parts from
t
®
Models:
the balance:
– Weighing pan (1)
– Pan support (2)
– Shield disk (3)
– Remove glass panels from the draft
shield (4): see next chapter, "Care and
Maintenance."
Turn the draft shield lock to
t
"unlocked."
Next, remove the wind shield from
t
the balance.
® ® ® 7
, Quintix , Practum