Use Procedure; Maintenance - Agilent Technologies Turbo-V 81-AG Notice De Mode D'emploi

Use Procedure

Controller Startup
To startup the controller plug the power cable into a suitable power
source.
Starting the Pump
To start the pump, confirm the interlock input and press the START
pushbutton on the controller front panel.
Pump Shutdown
To shutdown the pump press the STOP push-button on the controller
front panel.

Maintenance

The Turbo-V 81-AG Rack series controller does not require any
maintenance. Any work performed on the controller must be carried
out by authorized personnel.
When a fault has occurred it is possible to use the Agilent repair
service. Replacement controllers are available on an advance
exchange basis through Agilent.
WARNING! Before carrying out any work on the controller, disconnect it from the supply.
If a pump is to be scrapped, it must be disposed off in accordance
with the specific national standards.
Turbo-V 81-AG Rack Controller User Manual / 87-900-986-01
Instructions for Use
Use Procedure
(I)
16
203/306