Use Procedure; Maintenance; Controller Startup; Starting The Pump - Agilent Technologies Turbo-V 1001 Rack Mode D'emploi

Use Procedure

Controller Startup

To startup the controller plug the power cable into a suitable power
source.

Starting the Pump

To start the pump press the START/STOP push-button on the
controller front panel.
In order to start the pump the Interlock safety connection must be secured. This
NOTE
can be achieved by connecting to J1 connector the supplied mating connector.

Pump Shutdown

To shutdown the pump press the START/STOP push-button on the
controller front panel.

Maintenance

The Turbo-V 1001 Rack Controller does not require any maintenance.
Any work performed on the controller must be carried out by
authorized personnel.
When a fault has occurred it is possible to use the Agilent repair
service. Replacement controllers are available on an advance
exchange basis through Agilent.
Turbo-V 1001 Rack Controller User Manual / 87-901-033-01
Instructions for Use

Use Procedure

203/288
16