Agilent Technologies Turbo-V 81-AG Notice De Mode D'emploi page 252

17 Technical Information
How to Use by Front Panel
Low Speed
1
The front panel LOW SPEED function is available only if the controller is set to
NOTE
"FRONT" mode; error message is returned.
If it is set to "REMOTE" mode, the COMMAND LOCKED IN REMOTE error
message is displayed while if it is in "SERIAL" mode the "COMMAND LOCKED
IN SERIAL MODE" error message is returned.
Counters
1
Where
CYCLE XXXX Number of start/stop cycles
TIME XXXXXm
Pump Life
XXXXXX
252/306
Press once to activate the LOW SPEED command; press again to
deactivate.
Pressing the first time on the display, the following information is
displayed:
C Y
T I M
2
Pressing a second time, the following is displayed:
P U M
X
total operating time (hours) of the pump
Turbo-V 81-AG Rack Controller User Manual / 87-900-986-01
C L E X
E X X
Time of last cycle (minutes)
P L I
X X X X X
X X X
X X X m
F E
h
(I)