Agilent Technologies Turbo-V 81-AG Notice De Mode D'emploi page 296

17 Technical Information
Error Messages
Error Messages
For a certain type of failure, the controller will self-diagnose the
error and the following messages will be displayed.
If the pump is not connected, the display will be as shown in the following figure.
NOTE
C
1
If the P1 input connector is not in position with the link or the external interlock
NOTE
connections are open, when the START pushbutton is pressed the display will be
as shown in the following figure.
1
If within each step of the soft start mode the rotational speed of the pump do not
NOTE
reach the planned value within 15 minutes the display will be as shown in the
following figure.
296/306
H E C K
T O
Check connection between controller and pump, then press STOP
push-button twice to start the pump.
W
I N
Disconnect connector P1 and check the link or the external
interlock, then install the connector to start the pump.
Turbo-V 81-AG Rack Controller User Manual / 87-900-986-01
C O N N E
P U M P
A I T I N
T E R L O
C T I O N
G
C K
(I)