Agilent Technologies Turbo-V 81-AG Notice De Mode D'emploi page 256

17 Technical Information
How to Use by Front Panel
Black rectangles as shown below may be displayed at any time in the
first and last box of the bottom line of the display (opposite the LS /
AG / R1 / R2 captions). The meaning of these rectangles is as
follows:
LS → the controller is at LOW SPEED
AG → the Gauge is connected to the controller
R1 → relay (set point ) R1 is active
R2 → relay (set point ) R2 is active
Figure 32
256/306
REMOTE: remote mode (the controller accepts START/STOP and
LOW SPEED commands via the rear connector)
RS232: the controller accepts commands from the serial port
according to the RS232 standard.
RS485 [XX]: the controller accepts commands from the serial
port in RS485 mode with address XX (XX from 0 to 31)
PROFIBUS [YYY]: the controller accepts commands from the
PROFIBUS port with address YYYY
LS
AG
Turbo-V 81-AG Rack Controller User Manual / 87-900-986-01
R1
R2
(I)