After Each Use - Medela Symphony Mode D'emploi

5.2 After each use

1
Disassemble the pump set into its individual
parts (bottle, breast shield, connector, valve
head, valve membrane, membrane cap,
protective membrane and tubing). To remove
the white membrane from the yellow valve
head, use two fingers with one gently
pushing onto the "knob". Check all parts for
damage. Replace damaged or worn parts.
4
Drying / storage Drying / storage
Dry with a clean cloth or leave to dry
on a clean cloth.
Put the clean parts in a clean storage
bag or a clean environment. It is
important that all residual moisture
dries. Do not store parts in an airtight
container/bag.
2
I No milk, condensation or visible
residues in the tubing
No cleaning needed.
I With milk, condensation or visible
residues
Clean the tubing as described in step 3,
then disinfect it by boiling it in water for 5
minutes. Shake out any water drops. Let
the pump run with the tubing attached
until the tubing is dry.
Dishwasher
or 5
As an alternative to the previous
steps 3 and 4, you can also clean the
pump set in the dishwasher. Place all
parts, except for the tubing, on the
top rack or in the cutlery section. Use
a commercially available dishwashing
detergent.
15
step 3