Installation; Safety Instructions; Installing The Rotary Actuator - Burkert LCIE 07 ATEX 6078 X Instructions De Service

Type 3004

Installation

7. INSTALLATION
7.1.

Safety instructions

DANGER!
Risk of electric shock!
There is a serious risk of injury when reaching into the device.
• Always disconnect the power and secure it from re-activation before removing the cover, disconnecting the
gears or using the lever.
• Connect several rotary actuators always with phase separation via a switch!
• Protect the rotary actuators with a mains-operated fuse!
• Observe applicable accident prevention and safety regulations for electrical equipment!
WARNING!
Danger - improper installation!
Improper installation may result in injuries as well as damage to the device and the area around it.
• Installation may be carried out by authorised technicians only and with the appropriate tools!
• Observe the specifications in chapter 6 Technical Data.
Danger due to unintentional activation of the device!
Unintentional activation of the device during installation may result in injuries and damage.
• Take appropriate measures to prevent the device from being accidentally actuated.
7.2.

Installing the rotary actuator

The rotary actuator is supplied with the presetting <Closed>.
The rotary actuator can be fitted to a ball valve or flap valve via the following fastening options:
• ISO F05 (4 x M6 with a flange Ø of 50 mm)
• ISO F07 (4 x M8 with a flange Ø of 70 mm)
• ISO F10 (4 x M10 with a flange Ø of 102 mm)
7.2.1. Shaft end
The sizes of the inner star shape of the shaft end depend on the size of the actuator. Only the standard size of the
inner star shape is enclosed with each actuator (see table).
Actuator size [Nm]
45 / 75
100 / 150 / 300
25
Standard size of the inner star shape [mm]
17 / 11
22 / 14
22 / 17
English
19