Type 3004
Installation
8.3.2.
Parameterization steps
Specify direction of rotation of the shut-off valve
Normal direction of rotation (preset)
G
Reverse direction of rotation
R
Specify control signal type
Control signal when voltage 0 – 10 V
R
Control signal when current 0 – 20 mA
R
Control signal when current 4 – 20 mA (preset)
R
→
Press <OPEN> push-button and switch on the card (hold down
push-button).
The GREEN LED lights up.
→
Release <OPEN> push-button and disconnect the card from the power
supply.
→
Press <CLOSE> push-button and switch on the card (hold down
push-button).
The RED LED lights up.
→
Release <CLOSE> push-button and disconnect the card from the
power supply.
→
Press <MEM> push-button and switch on the card (hold down
push-button).
The RED LED lights up 3x.
→
Release <MEM> push-button and disconnect the card from the
power supply.
→
Press <MEM> and <OPEN> push-buttons and switch on the card
(hold down push-button).
The RED LED lights up 3x.
→
Release <MEM> and <OPEN> push-buttons and disconnect the
card from the power supply.
→
Press <MEM> and <CLOSE> push-buttons and switch on the card
(hold down push-button).
The RED LED lights up 3x.
→
Release <MEM> and <CLOSE> push-buttons and disconnect the
card from the power supply.
English
29