Replacing The Grey "T" Shaped Film-Retainer Profile - Orved VGP25N Mode D'emploi Et D'entretien

10.9 REPLACING THE GREY "T" SHAPED FILM-RETAINER PROFILE

WARNING:
This operation must be carried out by qualified personnel.
1) Lower the sealing head and fix it in the closed position
by means of the hook
2) Release the two side hooks fixing the steel cover
3) Remove the cover O
4) Deactivate the electric connector
Q
locking lever .
5) Detach the two tubes, red and black
green or orange plastic ring nut on the union, pulling
the tube at the same time.
7) Lift the entire sealing unit
taking care to avoid damaging the threaded insertion
pins and the cutting units (blades and film-retainer
profiles).
8) Remove the grey " T" film-retainer profile
dust residua, if present.
9) Insert the new profile, pushing it all the way into the hollow seat.
10) Insert the sealing unit, by centring the four threaded pins, then tighten
S
the knobs .
11) Insert the 2 red and black tubes in the two unions, pushing them to fit
flush (approx. 7mm). Insert the electric connector, blocking it by means
of the trip lever.
12) Hook the stainless steel cover, guiding with one hand the corrugated tube
V
on the back into the opening provided in the cover.
S
Rev. 08 - 04/2017 - Cod. 1500160 - Instruction manual VGP25N / VGP60N
M
present on the right side.
and raise it.
P
by acting on the
R
pushing on the
T
using the two handles,
U
and clean the seat to remove
S
Q
N
.
M
R V
P
U
ROUTINE MAINTENANCE
N
O
T
49