Operation Vgp25N; Control Panel Vgp25N - Orved VGP25N Mode D'emploi Et D'entretien

INSTALLATION AND PREPARATION
12) Seek the film roll.
A
Rest the film roll on two rollers
Feed the film under the film-retainer blade
the container.
C
10) Temperature adjustment
The heat-sealing machine is factory-set at a standard value
of 170°; to change the temperature value, which depends
on the type of film and container material:
1) Press the key
2) Set the desired temperature using
3) Exit programming by pressing
To determine the correct sealing temperature, consult
the technical tables of the materials being used.
WARNINGS!
• The product to be packed must be dry and cold for the maximum vacuum to be reached (read Chap. 6 ca-
refully). Always dry the vacuum chamber and the plastic panels thoroughly.
7. OPERATION: VGP25N

7.1 CONTROL PANEL VGP25N

3
2
4
28
B
on the rear and central part of the machine by means of two adjuster screws
D taking care to make sure the side of the film for sealing is facing
A
: is displayed.
.
11
5
B
.
9
12 10
Rev. 08 - 04/2017 - Cod. 1500160 - Instruction manual VGP25N / VGP60N
D
6
1
8 7
C
C