Parameters Modification Screen (Displayed By Pressing Modify); Maximum Programmable Values Vgp60N; Programming; Programming Parameters Temp / Vac / Vac+ / Gas / Sald - Orved VGP25N Mode D'emploi Et D'entretien

• SALD: sealing time (0-7 seconds)
• STOP: immediate stop of the cycle.
• DEGAS ON/OFF: indicates whether functions are activated/deactivated. This function allows reaching the vacuum
value set for the subsequent phases (up to a maximum of three). With the Degas ON function, air vacuum occurs only
through the top mobile part of the vacuum chamber (see § 8.2.2).
• A MAX / A MIN: indicates whether air vacuum in the tank is taking place from the top and bottom part of the tank (MAX)
or only from the top part (MIN).

8.1.3 PARAMETERS MODIFICATION SCREEN (DISPLAYED BY PRESSING MODIFY)

• INFO: provides information on the parameter to program.

8.1.4 MAXIMUM PROGRAMMABLE VALUES VGP60N

FUNCTION
VACUUM
ADDITIONAL VACUUM
SEALING
GAS INJECTION
SEALING TEMPERATURE

8.2 PROGRAMMING

8.2.1 PROGRAMMING PARAMETERS TEMP / VAC / VAC+ / GAS / SALD

1) After having performer calibration and first start-up, press ON to access the parameter display screen.
2) Select the program number to modify with keys +/-.
3) Access the parameter modification screen by pressing MODIFY.
1
Rev. 08 - 04/2017 - Cod. 1500160 - Instruction manual VGP25N / VGP60N
• SAVE: memorises set parameters to then return to the parameters screen.
• DIGITS 0-9 NEXT TO SAVE: program activated.
• DEGAS: activates/deactivates the vacuum mode for subsequent phases (see §
8.2.2).
• A INF ON/OFF: activates/deactivates the vacuum of the lower tank.
• E****E: key that allows access to the programs reserved to technical support
operators. It requires a password to have access.
• +/-: allows varying the value parameter displayed under the second column.
3
PROGRAMMABLE VALUES
0 - 100%
0 - 20 sec
0 - 7 sec
0 - 110%
0 - 250°C
OPERATION VGP60N
2
35