Start-Up; Handpiece - Ivoclar Vivadent Bluephase PowerCure Mode D'emploi

3. Start-Up

Check the delivery for completeness and any possible
transportation damage (see List of parts). If parts are
damaged or missing, contact your Ivoclar Vivadent
representative.
Charging base
Before you switch on the device, make sure that the
voltage mentioned on the rating plate complies with
your local power supply.
Slide the connection plug of the power pack into the
socket on the underside of the charging base. Tilt it
slightly and apply slight pressure until you hear and feel
it snap into place. Place the charging base on a suitable,
flat table top.
Connect the power cord with the power supply and the
power pack. Make sure that the power cord is easily
accessible at all times and and can easily be disconnect-
ed from the power supply. The charging base will briefly
display "Bluephase PowerCure" as ticker text on the
screen.
10

Handpiece

Unpack the handpiece from the packaging and detach
the light guide by pulling it out. Then clean the
handpiece and light guide (see Maintenance and
Cleaning). After cleaning, reinsert the light guide.
For reasons of hygiene, we recommend using a
disposable protective sleeve for each patient
(see Maintenance and Cleaning). Make sure to fit the
protective sleeve snugly to the light guide. Sleeves
enclosed in the delivery form may be used or sleeves can
be purchased per country specific regulations. Then,
attach the anti-glare cone or anti-glare shield to the light
guide.