Installation And Initial Start-Up; Unpacking And Checking The Contents; Assembly And Initial Set-Up; Handling And Operation - Ivoclar Vivadent Stratos 300 Mode D'emploi

4. Installation and Initial
Start-up
4.1

Unpacking and checking the contents

Remove the components of the Stratos 300 from their packaging
and check the delivery for completeness.
Stratos 300 basic model:
1 x Stratos 300
1x Incisal plate 0°
1x Incisal indicator
2x Retentive base blocks
1x Plaster protection plate
1x Incline support holder
If certain parts are missing or damaged, contact your local Ivoclar
Vivadent Customer Service. We recommend keeping the original
packaging for possible future transportation purposes.
4.2

Assembly and initial set-up

Incline support holder
The incline support holder enables ergonomic handling of the
articulator. If mounted, it maintains the articulator at approx. a
45° angle. This position permits a superb overview of the model
mounted in the articulator.
7.1
Insert the incline support holder (7.2) into the holding device (7.1)
for the incline support holder. If necessary, the incline support hol-
der can be removed from the apparatus.
Secure the base block (33) to the articulator by means of the GI
knurled screw (2.1).
10

5. Handling and Operation

5.1

Centric position

The Stratos 300 features a precise centric locking system that can
be activated in the following positions:
5.1.1 Centric fixation (4.1) open
This position permits the simulation of jaw movements.
If the rubber bands (4.2) are removed, the two frames can be
separated.
7.2
4.1
4.2