Installation And Initial Start-Up; Unpacking And Checking The Contents; Selecting The Location - Ivoclar Vivadent Quick Mode D'emploi

4. Installation and Initial Start-up

4.1

Unpacking and checking the contents

Remove components from their packaging and place the unit on
a suitable table. There are no special transportation grips on the
unit. Support the bottom of the unit with both hands to carry it.
Never carry the unit by holding the swivel arm.
Check the delivery for completeness (see "Delivery Form" in
Chapter 9) and transportation damage. If certain parts are missing
or damaged, contact your local Ivoclar Vivadent Customer Service.
We recommend keeping the original packaging for future trans-
portation purposes.
4.2

Selecting the location

Place the unit on a flat surface using the rubber feet (8). Make
sure it is not placed in the immediate vicinity of heaters or other
sources of heat. Furthermore, protect the unit from direct sunlight.
Make sure the air may properly circulate between the wall and
the unit.
Position the unit in such a way that glare-free working is ensured
and no direct view into the lamp is possible.
Make sure that there is enough space for the swivel arm (18) to
prevent obstruction of the swivel mechanism. The unit should
neither be placed nor operated in areas where there is an
explosion hazard.
10
4.3 Assembly and initial start-up
Step 1: Assemble anti-glare shield
Insert the anti-glare shield (3) into the respective guiding slots of
the anti-glare shield holder (4).
Step 2: Connections
Power connection:
Make sure that the voltage indicated on the rating plate (23) and
on the voltage selector complies with the local power supply.
Should this not be the case, you must not connect the unit.
Insert the power plug (16) into the power socket (7) of the unit
and connect the power cord (17) with the wall socket.
4
Step 3: Initial start-up
The unit may only be switched on or off with the On/Off switch
(5) at the rear of the unit.
Switched on
Switched off
Description of the stand-by indicator (2):
Green indicator
During operation, the stand-by indicator (2) next to the sensor
lights up in green, indicating 'ready for use'.
Red indicator
If the stand-by indicator (2) lights up in red, the lamp is too hot or
there is a technical defect. Please refer to Chapter 8.
3