Using The Auto Set Cs2; Starting Treatment; Stopping Treatment; Standby Mode - ResMed AutoSet CS 2 Manuel Utilisateur

eng.book Page 21 Friday, November 3, 2006 2:43 PM
U A
SING THE
WARNING
!
Before starting therapy with a new mask, select the correct mask type in the
Settings menu (page 26). When adding or removing a new component such as a
mask, humidifier or anti-bacterial filter, perform the Air Circuit Learn function
(page 26).
S T
TARTING REATMENT
When the system is fully assembled, press the power switch at the back of the
A S CS2 to ON. The Welcome screen will be displayed while the flow
UTO ET
generator is warming up. Allow the unit to warm up for approximately 30 seconds
before placing the mask on your face.
WELCOME
Figure 12: Welcome screen
Once the A
UTO
immediately. If not, press the Start/Stop key once to commence treatment.
A S
The
UTO ET
S T
TOPPING REATMENT
If S S
is enabled, treatment will stop automatically when you remove your
MART TOP
mask. If the S
MART
S M
TANDBY ODE
AUTOSET CS2
menu
Figure 13: Standby screen
Once you have stopped treatment, the A
standby you can:
press the power switch at the back to OFF to turn off the flow generator
•
commence treatment again by breathing into the mask or pressing the Start/
•
Stop key
enter any of the menus by pressing the Left key.
•
When in standby mode, a gentle (non-therapeutic) flow of air will still be present.
If the SMART DATA - AUTO APPEAR option is set to ON, the screens available under the
N
OTE
Results menu will be displayed automatically for approximately 20 minutes after your
session is completed.
S CS2
UTO ET
S CS2 has warmed up, breathing into the mask should start therapy
ET
CS2 restarts in the mode in which it stopped.
S function has been disabled, press the Start/Stop key.
TOP
S CS2 will be in standby mode. In
UTO ET
U A
SING THE UTO
S CS2
ET
21