Humid Aire - ResMed AutoSet CS 2 Manuel Utilisateur

eng.book Page 15 Friday, November 3, 2006 2:43 PM
H A
UMID IRE
You will need a Medium size (52cm) air tube to connect the A
H A ™ (see Figure 7).
UMID IRE
1
Make sure both the H
Fill the H A
UMID
water chamber inside the H
2
Gently detach enough of the tube clips to release the end of the pressure sensor tube
from the A
UTO
Connect the A
UTO
the medium (52cm) air tubing to the right connector port. Close the H
HumidAire
AutoSet CS2 air tubing
3
Place the A
UTO
unit underneath the humidifier. (This is to avoid water spilling into the unit.)
A and the A
UMID IRE
with water as described in the humidifier manual. Place the filled
IRE
A
.
UMID IRE
S CS2 air tubing.
ET
S CS2 air tubing to the left connector port on the humidifier, and
ET
Medium air tubing
S CS2 on top of the H
ET
S
UTO
S CS2 are turned off.
UTO ET
Pressure sensor tube
A . Do not place the A
UMID IRE
T A S
HE UTO ET
CS2 unit to the
ET
A
lid.
UMID IRE
S CS2
UTO ET
CS2 S
YSTEM
15