Res Link; Anti - Bacterial Filter - ResMed AutoSet CS 2 Manuel Utilisateur

eng.book Page 17 Friday, November 3, 2006 2:43 PM
CAUTION
!
Be very careful not to allow water to enter the A
•
could affect therapy and/or damage the device.
Do not tip the H
•
If water enters the A
back of the unit and unplug it from the power outlet. Return the unit to your
equipment supplier for checking.
Set up the H
•
runs higher than the machines. This will prevent condensation build-up.
If condensation appears in the mask, turn the humidifier settings down.
•
R L ™
ES INK
The R L ™ is a device that records data onto a SmartMedia™™ card during your
ES INK
therapy. The card can be returned to your clinician so that they can observe your
progress and adjust flow generator parameters if necessary. The R
the back of A
UTO
to the ResLink User’' s Manual.
A -
NTI BACTERIAL
Your clinician may recommend that you use an anti-bacterial filter. A filter should be
placed in the air tubing between the mask and the flow generator. If using a humidifier,
place the filter between it and the flow generator (see Figure 10 below).
Typically, the filter should be replaced daily. Check the filter instructions for full details.
Whenever a filter is added, removed or replaced you must run the Air Circuit Learn
function (see “"Learn Circuit”" on page 26).
Only hydrophobic anti-bacterial filters should be used with a
N
OTE
A while it is connected to the A
UMID IRE
S CS2 device, turn off the main power switch at the
UTO ET
A and the A S
UMID IRE UTO
S CS2 as shown. For full details on using the R
ET
F
ILTER
S
UTO
CS2 unit so that the tubing to the mask
ET
ES
ES
H A 2i
or
UMID IRE
T A S
HE UTO ET
CS2 as this
ET
S CS2.
UTO ET
L
connects to
INK
L , please refer
INK
H A 2i C.
UMID IRE
CS2 S
YSTEM
17