Servicing Menu; Treatment Screens - ResMed AutoSet CS 2 Manuel Utilisateur

eng.book Page 29 Friday, November 3, 2006 2:43 PM
S
ERVICING MENU
This menu displays the following information:
SN –– the flow generator’' s serial number
•
PCB –– the flow generator’' s PCB number (PCB —— printed circuit board)
•
SW –– the version of software currently installed on the flow generator.
•
T S
REATMENT CREENS
There are three Treatment screens displayed in the A
will display the Treatment screens when treatment commences, and during treatment
if no key is pressed for 20 minutes.
Press the QuickView key at any point within a menu to display Treatment
Screen 1. You can return to your original screen if you press the QuickView
key again within 20 minutes.
Press the Right key to move from a Treatment screen to the Standby screen.
If an alarm is triggered while you are in the Treatment screens, the arrow will flash.
Press the Down key until you reach the alarm message.
Scroll through the screens in the usual way, using the Up/Down key.
Treatment mode
ASV-CS 5.0--15.0
Figure 17: Treatment Screen 1
Leak
LK:18L/min
APNEA
Apnoea / Hypopnoea
(if present)
Figure 18: Treatment Screen 2
Minute ventilation
MV:6.2
Figure 19: Treatment Screen 3
TARG is not a relevant parameter in CPAP mode.
N
OTE
Pressure
exit
Respiratory rate
RR:12
VT: 428
Tidal volume
Target ventilation
TARG:5.8
exit
S CS2 LCD. The LCD
UTO ET
U A S CS2
SING THE UTO ET
29