Masks - ResMed AutoSet CS 2 Manuel Utilisateur

eng.book Page 10 Friday, November 3, 2006 2:43 PM
Proximal cuff
Connect this end
to the mask
Figure 3: Air tubing fully assembled
All necessary air tubing components are packed with the A
a 2-metre length of air tubing
•
a pressure sensor tube (to measure pressure at the mask) with Luer connectors
•
tube clips (to hold the pressure sensor tube onto the air tubing)
•
a Proximal cuff (a special connector that attaches the pressure sensor tube into
•
the main air tubing so that you only need to make one attachment to the mask).
The air tubing is supplied with the Proximal cuff connected. Attach the tube clips
evenly along the air tubing. Press the pressure sensor tube into the tube clips, and
screw the Luer connectors together at the Proximal cuff. Make sure the pressure
sensor tube is not kinked, obstructed or twisted.
ResMed recommends the following tubing products for use with the AutoSet CS2:
N
OTE
replacement air hose (only) PN 14948; replacement air delivery system (hose, sensor line,
clips, proximal cuff) PN 26909.
M
ASKS
The following mask systems (supplied separately) are recommended for use with the
A S CS2 system. Please refer to the table on page 26 to set up your mask
UTO ET
correctly for use with the A
U
LTRA
F
ULL
M
IRAGE
Your clinician can explain the features of the masks available, and will discuss the mask
that best suits your needs.
10
Tube clip
Air tubing
S CS2.
UTO ET
M
™
M
IRAGE
IRAGE
M
F M ASK
ACE ASK
™
A
U
CTIVA
Pressure sensor tube
Connect this end
to the flow generator
UTO
™
F F
ULL ACE
S 2
ERIES
™
M
LTRA IRAGE
Luer connector
S CS2:
ET
™
M V
IRAGE ISTA
P
APILLON