Using Dc Power To Run The Auto Set Cs2 - ResMed AutoSet CS 2 Manuel Utilisateur

eng.book Page 18 Friday, November 3, 2006 2:43 PM
Anti-bacterial filters
Figure 10: Inserting anti-bacterial filters
U DC P R A S CS2
SING OWER TO UN THE UTO ET
The A S CS2 can be run on DC current in case of power failure or for portable
UTO ET
use. ResMed supplies a convertor that allows a 12V battery to be connected to the
DC input of the A S CS2. The converter can also be plugged in to a power
UTO ET
source in a car or plane. When using DC current, power is turned on and off via the
switch on the connector to the power source, not the power switch at the back of the
A S CS2. The DC converter is a separate accessory that can be purchased
UTO ET
through your ResMed distributor.
The humidifer heater will be automatically disabled when the A S CS2 is
UTO ET
operating from the DC supply.
S CS2 varies with treatment settings. A typical
Power consumption of the A
UTO ET
current of between 2.5A and 3.0A will be drawn from a 12V battery during use.
Adequate battery type and sizing is required before operation on DC, and it is
recommended that ResMed’' s Technical Services division be contacted for information
on your specific application.
CAUTION
!
The A S CS2 uses 30V DC power. Only connect the A S CS2 to DC
UTO ET UTO ET
power using the ResMed DC-DC convertor specified for this application.
18