Quick Setup Guide - ResMed AutoSet CS 2 Manuel Utilisateur

eng.book Page 7 Friday, November 3, 2006 2:43 PM
Q S
UICK ETUP
1
Attach the air tubing and pressure sensor tube to the A
mask (page 11).
2
Attach a humidifier if required (page 13).
3 Switch on the A
4
Select the mask setting (page 26).
5
Perform the Air Circuit Learn function (page 26) at first-time use, or if you
are adding or removing a component of the system (eg a humidifier or anti-
bacterial filter).
6 Fit the mask and commence breathing into it. The S
should trigger treatment to commence within the first couple of breaths. If
not, press the Start/Stop key once to commence treatment (page 21).
You can observe treatment progress (eg mask leak) via the Treatment screens (page 29).
N
OTE
7
Remove your mask to stop treatment. If S
will stop automatically. If the S
the Start/Stop key once.
G
UIDE
S CS2. Make sure the mask is unblocked.
UTO ET
S
MART TOP
S
UTO ET
S
MART TART
S
is enabled, treatment
MART TOP
function has been disabled, press
Q S G
UICK ETUP UIDE
CS2 and
function
7