ero electronic TMS Mode D'emploi page 19

DIRECT ACCESS TO THE SET POINT DIRECT ACCESS TO THE SET POINT DIRECT ACCESS TO THE SET POINT DIRECT ACCESS TO THE SET POINT DIRECT ACCESS TO THE SET POINT
MODIFICATION MODIFICATION MODIFICATION MODIFICATION MODIFICATION
The instrument allows to modify the set point
value without to use the FUNC push-button.
When a rapid set point modification is required,
proceed as follows:
1) Pushing, for more than 3 seconds, the
push-button; the set point value, shown on
the lower display, will start to change.
2) Using the and push-buttons, it is
possible to set the desired value.
3) When the desired value is reached, do not
push any push-button for more than 3
seconds, the new set point will become
operative after 3 seconds from the last push-
button pressure.
If, during this procedure, it is desired to lose the
new value, push the FUNC push-button; the
instrument automatically returns to the normal
display mode without to memorize the new set
point.
LAMP TEST LAMP TEST LAMP TEST LAMP TEST LAMP TEST
When it is desired to verify the display efficiency,
push and FUNC push-buttons. The instrument
will turn ON, with a 50 % duty cycle, all the LED
of the display (we define this function "LAMP
TEST").
No time out is applied to the LAMP TEST.
When it is desired to come back to the normal
display mode, push and FUNC push-buttons
again.
No other keyboard function is available during
LAMP TEST.
OPERATIVE PARAMETERS OPERATIVE PARAMETERS OPERATIVE PARAMETERS OPERATIVE PARAMETERS OPERATIVE PARAMETERS
Operative parameter modification Operative parameter modification
Operative parameter modification Operative parameter modification Operative parameter modification
Push the FUNC push-button, the lower display
will show the code while the upper display will
show the value or the status (ON or OFF) of the
or
selected parameter.
By or push-button it is possible to set the
desired value or the desired status.
Pushing the FUNC push-button, the instrument
memorizes the new value (or the new status) and
goes to the next parameter.
A pressure of the SMRT push-button allows to come
back to the previous parameter without to memorize
the new set of the actual parameter.
Some parameters may be not visualized according
to the specific instrument configuration.
NOTE: 1) NOTE NOTE If, during operative parameter
NOTE NOTE
modification, no push-button is
pressed for more than 10 seconds,
the instrument reverts automatically
to the "normal display mode" without
to memorize the last parameter
setting.
2) The instrument do not display all
parameter but it select the
parameter in accordance with:
a) the instrument configuration
b) P25 setting
c) the proportional band setting.
GB GB GB GB GB 16