ero electronic TMS Mode D'emploi page 15

P16 = Measure of the current consumed by P16 = P16 = P16 = P16 = Measure of the current consumed by Measure of the current consumed by Measure of the current consumed by Measure of the current consumed by
the load driven by the main output the load driven by the main output the load driven by the main output the load driven by the main output the load driven by the main output
(HBD) (HBD)
(HBD) (HBD) (HBD)
OFF = measure disabled
n.O. = measure enabled during the ON period
(logic status 1 for SSR output or contact
NO for relay output)
n.C. = measure enabled during the OFF period
(logic status 0 for SSR output or contact
NC for relay output)
P17 = P17 = Full scale of the current transformer. Full scale of the current transformer.
P17 = Full scale of the current transformer. P17 = P17 = Full scale of the current transformer. Full scale of the current transformer.
Available only when P16 is different from OFF.
10 = 10 A (resolution: 0.1 A)
25 = 25 A (resolution: 1 A)
50 = 50 A (resolution: 1 A)
100 = 100 A (resolution: 1 A)
P18 = Safety lock P18 = Safety lock P18 = Safety lock P18 = Safety lock P18 = Safety lock
0 = device unlocked. All the parameters can be
modified
1 = device locked. No one parameters can be
modified exception made for SP.
From 2 to 499 = during operative mode, SP
parameter can be modified and
this number allows to enable/
disable the modification of all the
other parameters.
From 500 to 999 = SP, A1 and A2 parameters
can be modified and this number
allows to enable/disable the
modification of all the other
parameters.
NOTE NOTE NOTE: After FUNC push-button pressure it will be
NOTE NOTE
impossible to display this value again. If you don't
remember the old key, set a new value.
The configuration procedure is completed and the
-.-.-.
instrument will show " " on both displays.
When it is desired to end the configuration
procedure push the FUNC push-button; the
display will show "COnF".
When it is desired to access to the advanced
configuration parameter, proceed as follows:
1) using and push-button set the 217 code.
2) push the FN push-button; the instrument will
start the auxiliary configuration procedure and
it will show the following additional param-
eters.
P19 - Main output action P19 - Main output action P19 - Main output action
P19 - Main output action P19 - Main output action
Available only when P4 = H.
r = Reverse (heating)
d = direct (cooling)
Note : when P4 = HC, this parameter is Note Note Note Note
equal to "r".
Reverse
Input Input
t
Output Output
t
P21 - Alarm 1 output action P21 - Alarm 1 output action P21 - Alarm 1 output action
P21 - Alarm 1 output action P21 - Alarm 1 output action
Available only when P7 is different from 0 and P4
is equal to H.
r = reverse (relay de-energized in alarm
condition).
d = Direct (relay energized in alarm condition)
GB GB GB GB GB 12
Direct
t
t