ero electronic TMS Mode D'emploi page 13

P3 = Full scale value P3 = Full scale value P3 = Full scale value P3 = Full scale value P3 = Full scale value
Not present when P1 = 5
Full scale value used by the PID algorithm to
calculate the input span.
P3 is programmable within the input span
selected by P1.
When P3 has been modified, the instrument
assignes to the rH parameter the new P3 value.
NOTE: the minimum input span (P3 - P2) is NOTE NOTE NOTE NOTE
- 300 °C or 600 °F for TC input
- 100 °C or 200 °F for RTD input.
P4 = Output configuration P4 = Output configuration P4 = Output configuration P4 = Output configuration P4 = Output configuration
H = heating
HC = heating/cooling
P5 = Main output type P5 = Main output type P5 = Main output type P5 = Main output type P5 = Main output type
rEL = Relay output.
SSr = SSR output.
NOTE NOTE NOTE NOTE: NOTE
Setting P5 = rEL, the C parameter will be
automatically set to 20 s.
Setting P5=SSr, the C parameter will be
automatically set to 2 s.
P6 = Cooling output type P6 = Cooling output type P6 = Cooling output type P6 = Cooling output type P6 = Cooling output type
Available only when P4 = HC
AIr = air
OIL = oil
H2O = water
NOTE: NOTE NOTE NOTE NOTE
Setting P6 = Air, the C2 parameter will be
automatically set to 10 s
and rC parameter will be
set to 1.00.
Setting P6=OiL, the C2 parameter will be au-
tomatically set to 4 s and rC
parameter will be set to 0.80.
Setting P6=H2O, the C2 parameter will be au-
tomatically set to 2 s and rC
parameter will be set to 0.40.
P7 = Alarm 1 P7 = Alarm 1
P7 = Alarm 1 P7 = Alarm 1 P7 = Alarm 1
Available only when P4 = H.
0 = Not provided
1 = Process alarm
2 = Band alarm
3 = Deviation alarm
P8 = Alarm 1 operative mode P8 = Alarm 1 operative mode P8 = Alarm 1 operative mode P8 = Alarm 1 operative mode P8 = Alarm 1 operative mode
Available only when P7 is different from 0 and
P4 = H.
H.A = high alarm (outside band) with automatic
reset
L.A = low alarm (inside band) with automatic reset
H.L= high alarm (outside band) with manual reset
L.L= low alarm (inside band) with manual reset
P9 = Stand by (mask) of the alarm 1 P9 = Stand by (mask) of the alarm 1 P9 = Stand by (mask) of the alarm 1 P9 = Stand by (mask) of the alarm 1 P9 = Stand by (mask) of the alarm 1
Available only when P7 is different from 0 and
P4 = H.
OFF = stand by (mask) disabled
ON = stand by (mask) enabled
NOTE NOTE
NOTE NOTE: the alarm stand by function allows to NOTE
disable the alarm indication at instrument start up
or, for band and deviation alarms, after a set point
modification.
The alarm will be automatically reactivated when
the initial alarm condition disappears.
GB GB GB GB GB 10