Publicité
Manometeret viser det reducerede tryk, der
er til rådighed i Plasmaslangen.
Vandudskilleren: For at sikre plasma-
brænderen en lang levetid, bør brugeren
med jævne mellemrum kontrollere at vand-
standen i vandudskillerens vandglas ikke
er over 2-3 cm fra glassets bund.
Hvis vandstanden er for høj, klemmes
bundventilen op, imens der er tilsluttet
trykluft. Herved vil vandet lukkes ud og evt.
snavs "blæses" ud.
Pos. 5
Stik for fjernregulering og strømforsyning til
brænderfremføringsenhed. (ekstra udstyr).
Pos. 6
ON-indikator
Den grønne lampe lyser, når maskinen er
tændt.
Pos. 7
Skæreindikator
Den grønne lampe viser, at pistoltasten er
aktiveret, og pilotlysbuen eller skærelys-
buen er tændt.
Pos. 8
Trykluftindikator
Denne lampe lyser, hvis der er trykluftman-
gel, eller hvis der er et for lavt tryk. PDX kan
ikke aktiveres, hvis den røde lampe lyser.
Pos. 9
Overbelastningsindikator
En termosikring sikrer, at PDX ikke kan
overbelastes. Den gule lampe lyser, når
PDX er for varm, og maskinen kan ikke
aktiveres. Lampen slukkes når maskinen er
afkølet og atter er klar til brug.
Pos. 10
Trinomskifter
1 Lavt trin
= 45 A
2 Højt trin
= 85 A
The manometer shows the reduced pres-
sure which is in the plasma cutting hose.
The water separator: To ensure long life of
the plasma cutting torch, the operator
should control at regular intervals that the
water level in the water glass of the water
separator is not more the 2-3 cm from the
bottom of the glass.
If the water level is too high, press up the
foot valve while the compressed air is still
connected. In this way, the water is being
let out and dirt is being "blown" out.
Pos. 5
Plug for remote control and power supply
for the torch feed unit (extra equipment).
Pos. 6
Mains on indicator
The first green indicator lights when the
machine is switched on.
Pos. 7
Cutting indicator
The second green indicator lights when the
torch trigger is activated and the pilot arc or
the cutting arc is established.
Pos. 8
Compressed-air indicator
This first red indicator lights if there is a lack
of compressed air or if there is too low a
pressure. PDX cannot be activated if the
red indicator lights.
Pos. 9
Thermostatic control indicator
An overheating protection ensures that the
PDX cannot be overloaded. The yellow
indicator lights when the PDX is too hot,
and the machine cannot be activated. The
indicator extinguishes when the machine
has cooled down and is ready for use.
Pos. 10
Switch
1 Low step
= 45 amps
2 High step
= 85 amps
Publicité
